Eleaf LCD Meter

[vagaka]

Eleaf LCD Meter подскажите, стоит брать для замера сопротивления и проверки правильности намотки, защиты от кз или посмотреть что то другое.

[stereonyl]

The LCD meter can show you real time voltage/wattage with real vapor conditions.
The LCD meter can show you real time voltage/wattage with real vapor conditions. With traditional voltage meters, it only can show the voltage of the battery in a no-load condition, although it will not show you the drop of the voltage during real-time usage.
The benefit of testing with on-load condition with a quality battery is the voltage will remain as advertised during usage, as compared to a bad battery where the voltage will drop significant during usage.


1. Multi-functions like short-circuit protection, over-voltage and low-voltage protection, over-current protection.

2. Short-circuit protection: When the resistance is lower than 0.5Ω, the LCD Screen will show "E1" to raise an alarm.

How to use:
1. No-load Condition:
When only connecting to battery, press the battery button, the LCD Screen will first display "NoΩ"(meaning no resistance), then the virtual voltage of this battery.

2. On-load Condition:
When connecting to battery and atomizer in the same time, press the button, the LCD Screen will first display the virtual atomizer resistance, then the current voltage and wattage after 1 second. Less the battery power is, lower the voltage and wattage are.

ATTENTION : The LCD Meter cannot test the atomizer resistance when only connecting to an atomizer, as it has no power without a battery.

то есть , без батареи ты не посмотришь сопротивление намотки ....

мне кажется , что вот такой более подходит и удобнее ... на нем даже намотку удобно ставить на базу

Digital Ohm - and Voltmeter from Eleaf, it is fit for all Atomizer and Batteries with 510-Thread (510 adapter inclusive)
Standard Configuration:
1× Meter Device
1× Connector

Parameter of Digital Ohmmeter & Voltmeter
Range for tested resistance: 0.01 ohm to 9.99 ohm
Range for tested voltage: 0.01 V to 9.99 V
Operating voltage: 2.2V to 5.5V
Working current: Less than 10 mAh with no tested
object; less 30 mAh with tested object
Standby power consumption: Less 10 uA

Digital Ohmmeter & Voltmeterr is designed for testing resistance and voltage of e-cigarette products.
The size is very small, making it easy to test resistance and voltage at any time and place even for
the most basic e-cigarette user.

There are two ports on the Digital Ohmmeter & Voltmeter: The left one for testing voltage and the right one for testing resistance. (The ports are for eGo-threaded devices and the connector for 510-threaded devices.)

Step 1: Turn on the device. (The switch is near the port for testing resistance.)
Step 2: Screw the battery port of the e-cigarette onto one the voltage port of the device for testing its
voltage. When pressing the button on the battery of the e-cigarette, the reading of the voltage
will show in the LED display. Screw the atomizer onto the resistance port of the device for
testing its resistance. The ohm reading will show in the LED display.

You need 2 x AA Batteries, these are not inclusive!