https://www.e-cigarette-forum.com/fo...p-down.692979/
ATM running Magma, Kanthal Dual coil .65ohm
TI mode
15J
400F(experimenting with temp effect) 212 seemed very Mushy, 400 still so-so, but only 15 watts driving (2) coils - gotta verify power drop(yuck-lol)
Final result:
(TBA) Magma holds a lot of liquid
YUCK and Patuee!!!
Okay hated doing it but needed confirmation.
As speculated the low resistance shift is to tight to be read by either TC algorithm.
i.e. - MT mode will allow lower wattage Vaping as far as power supply goes using Kanthal/Nichrome builds.
The user will NOT, I repeat NOT have TC protection using Kanthal/Nichrome Coils.
As long as this is understood, it is no different than using a standard wattage solution.
The unit will also have a low limit of 10J(10 watts)
I comfortably vaped the Magma down to almost completely dry, pushing the edge of burning a wick(or2) but No Liquid message never kicked in.
I also set down to 212F with no change in warning.
The Vape was good(acceptable), even at my 15J setting with surprisingly decent vapor the whole time.
Upon refilling and confirming no damage to wicks/flavor I bumped up to 30J and the performance is excellent.
This tells me I will not have to switch back and forth should I decide to throw a Kanthal tank on the D2 at my typical wattage use.
There you have it. Use care and wade in slowly.
Get comfortable and enjoy!
Те кто сокрушался тому, что нет степдауна теперь довольны. У всех все работает, всем все нравится. (!!!не стоит забывать, что это делают ТОЛЬКО чтобы получить меньшие ватты на кантале, ТК как таковой на кантале не сработает, и не остановит нагрев спирали на сухой вате!!!)
