Features:
18650 VV Gripper can be adjusted from 3.0-6.0V volts in 0.1 volt increments.
18650 VV Gripper holds only one protected battery 18650 2200mah,allows 4V input voltage limit.
18650 VV Gripper PCB allows 4 Amperage output limit.
18650 VV Gripper standard load is 3Ω,it also could be working at 1.5Ω.
The meanings of the symbols shown by the screen are as following,
1.S1 --- Voltage down
2.S2 --- Voltage up
3.S3 --- Standby on/off
4.S4 --- Display on/off
S1---Voltage Down
"-" button, you can decrease the voltage from 6V to 3V by pressing this "-" button,when you reach 3V
it will rotate back around to 6.0 and go down again.
S2---Voltage Up
"+" button,you can increase the voltage from 3V to 6V,when you reach 6V it will rotate back around
to 3.0 and go up again.
S3---Standby On/Off
Under "Off" or"Standby mode" ,the atomizer/cartomizer will not be not activated by the 18650 VV Gripper when the button is
pressed and you will not be able to change any of the settings.
Under "On" mode, when you press the button,the current resistance will be displayed for 3 seconds.Afterwards, the battery
voltage will be displayed automatically.
This button has 5-click on/off fuction.
S4---Display On/Off
When the screen showing "On",then press the button, you could activate the device and the LED light,otherwise
you will not be able to enjoy the device.
Other Functions
1.Low Resistance Indicator : If the output resistance is below 1.2Ω,then press the button"S4",the device will
be warning you by displaying a error code "L0-Ω”
2.Short-cut Atomizer/Cartomizer :If there is ever a problem with your atomizer/cartomizer,then press "S4" the
device will alert you by displaying a error code "L0-V".
3.Low Battery Indicator:If the battery voltage is below 3.4V,then press the button"S4",the device will alert
you by displaying a error code "L0-V”
,Omega+Kick, Cube+Kick+GenisisLV
, TAIFUN Кастет+Нивел
ProNiVeLari, Trixie, By-l, Magoooo,Erl mini
Пока Дзен = Кастет+By-ka 
