Features
-- The 2nd generation Vapor Intelligent Chip
-- Upgradable Chip
-- 5W-50W Variable Wattage
-- 1.0V-9.5V Variable Voltage
-- Handle 0.2 ohm- 3.0 ohm Atomizer
-- The Output Volt Buck-Boost&Boost Available
-- By-pass (direct connection) mode, choose this mode,your vaporizer
can be used like mechanical mode
-- Gravity Sensor change the power automatically,up/down button for option
-- 0.66" OLED Screen
2014 High end Products YiHi SX350 50W
Single Battery DC to DC Sustain Subohm 0.2 to 3.0 ohm VV/VW 5W to 50W 1.0V to 9.5V Yihiecigar
Warning :
IF you're not skilled, experienced, and comfortable with Electronics, Soldering, and Safety you should not be purchasing this chip! It is intended for experienced individuals.
The Output Current of your battery be required above 25 A, otherwise we do not suggest you upgrade your SX350 to 50W !
Specs of YiHi SX350 50W Yihieicgar
No. Specs Minimum Typical Max
1 Output Power 5 Watts 50 Watts
2 Output Voltage 1.0 Volts 9.5 Volts
3 Output Current 25.0A
4 Atomizer Resistance 0.2 Ohms 2.0 Ohms 3.0 Ohms
5 Bypass (Direct Connection Mode) YES
6 Output Power (Bypass mode) 5 Watts (3 ohm) 80.0 Watts (0.2ohm)
7 Output Voltage (Bypass mode) Battery Voltage-0.09V
8 Output Current (Bypass mode) 1.33 A 25.0 A
9 Input Voltage (Battery required above 25A ) 3.2 Volts 3.7 Volts 4.5 Volts
10 Input Current 1.5 A 10.0 A 25.0A
11 Screen On Current 25 mA
12 Quiescent Current 1 mA
13 Power Down Current 350 uA
14 Efficiency 92%
15 Screen size 0.66" OLED
16 Fire Method Only One Regular Fire Button
17 Adjust Power Method Both Gravity Sensor & Up/Down Button adjust the Power
18 USB Charging for Battery Yes 1A
19 App controlled Bluetooth NO
20 Software Upgrade/GUI operate YES
21 Charging for Mobile Phone NO
22 Customize Logo YES (above 120pcs,we can customize the logo for you)
23 Protection:
1. Reverse Polarity Protection
2. Output Short Protection
3. Low Resistance Protection
4. Battery low voltage Protection
5. Temperature Protection
Important Notice:
1. After upgrading successfully, please remember Reset your chip. Disconnect the battery or use "Link" to reset the chip
(1. Press the fire button down&keep 5 seconds to read the version information.
2. Press 5 times quickly to start up the chip. 3. Go to "Link" and tilt right&keep 5 seconds untill the screen turn black. If unplug the USB, chip will start up automatically.)
2. The atomizer better less than 1 ohm. SX350 chip works better with subohm.
If you did not connect with atomizer, chip default to 2.5 ohm resistance.
You need use Gravity adjust the power less than 36.1W. In this way, all of the features can be used normally.
3. Re the Temperature Protection, when the chip works overheat, "too hot" warning will remind you. After counting from 10 to 0, you can keep vaping again.
4. If you amended any part of SX350 chip(specially the software or changed to other Micro USB), the port of USB maybe will be locked and unable to upgrade to 50W.
