NoTank RDA (bottom feeder)
What You Need
Mesh ( whichever you prefer ) , resistive ( 0.25 here ) , scissors , allen wrenches , tube 2mm (or toothpick )
cut a piece of mesh 40mm x 7mm (or higher if you like to fix the resistive to top screw)
oxidize it
Roll it on a tube 2mm (I used a box tube box)
From this transfer it to the positive pin of the NoTank
Once settled well, you should be able to catch a glimpse of the hole where you insert the resistive
Insert one end of the resistive and tighten the screw head
Wrap the resistive around then mesh , stop shortly after the hole of the negative screw and clamp it
Holding the resistive started leaving a couple of free spins
Mount the NoTank on the box and get somemicro activations until the cable will light evenly
get a squonk and activated again
Take a small wad of cotton
put it in the collection tank
squonk
Mount the cap, the cap over, the tip and vape it
---------------------------------------------------
Or You can try this
P.S.
Гараж не мой. сорри за инглиш
С уважением,
Инглиш ещё терпимо 
Сообщение от Enoh
Спалил, в смысле... 
! Надо взять на заметку
