ArDark

Сообщение от J80

GENISIS

The stainless steel mash, the kanthal-wire and the port to refuel.

1) It's a stainless steel mash with 37-57Micromters.
2) It's oxidated with a lighter, for 3 times.
3) This oxidation makes a not conductive skin on the mash
4) the mash has an capillar-effect, wich brings all the time the liquid from the tank to the top. You not need to invert it.
5) This system gives a 10-50 time higher lifetime to the atty.
6) Changing mash an Kanthal (the resitor-wire) need ony 3-4 minutes.

The advantage:
1) Absolutly pure liquid taste!
2) Never burned taste.
3) Fast changing of mash an Kanthal
4) the taste

in connection with my electronics, everyone can adjust the taste according to his wishes.


the code name for my new invention is genisis. Whenever i write genisis, it's this new atty.

Hope, you undertand this!

how to make the mesh/wick
The screen is cut to 14 * 40 mm (~ 1/2 inch * 2 inch) and rolled to 1,8-2.3 mm. Now it is boiled at least 5 minutes. The top is oxidized with the lighters. Two drops of liquid on top and again oxidize - done


1) Cook it 5 minutes
2) dry it
3) Take a lighter an glow it to the color of cherrys. 3 times and only on the top side, where the kanthal is.
4) Put 1 drop liquid and burn it with the lighter.
It should work well. The first 10-30 times it tastes not so good (dont inhale, blow it out). But then you get the absolutly real armone of the liquid like never taste before. Normaly the oxidation has no problem, when you wrapp the kanthal. So older the atty, so better is the oxidation.
======
"screen stainless steel". I prefere 300-400mash.
lower mash (250-300) = stromg throat hit, low steam, 400mash=much steam lower flash
Kanthal is also in ebay. You need 0,16-0,2mm diameter ore about 80-100Ohm/meter.
sorry wrong statement. the 0.2mm 45,86Ohm is perfect

The mesh wick tube is rolled into a spiral. So stronger, so dryer. So softer, so more trat hit. if you roll 14-15mm into a 2-2,3mm spiral it is the best choise to begin.

//Handy= cell phone/ mobile

mechanical steps:
1
The IC pins are soldered to the copper wire and then covered with shrink tube.
2
Making the screen and kanthal

3
If you a perfect in mechanics, i prefer using this way, because changeing kanthal and mash goes much faster:

It a very easy way to make the first steps with then new genisis atty

you need:
screen mash (325-400 mash)
kanthal wire 0,16mm or 0,2mm
piece of ceramic tile (from your bathroom)
screw and nut
any littel 2-10ml container
mouth tube (from a old PEN)

if stainless steel components are using you have a very "healthy" atty.

It's enough to learn how it works. Everybody can do it.