Hello community :)
It is time to present you the
Origen Genesis v2 wich is completely different from the v1 8-)
Materials used :
- Body and top cap: Stainless steel
- Center pin: Brass center pin (stainless steel center pin will be sold separately) with a 1.2mm hole at the end
- Knurled nuts: Stainless steel
- Inserts for single or dual coil use: Anodized aluminium (food grade)
- Tank material: Polycarbonate (Makrolon). Stainless steel tank will be sold separately
Measurements:
- Height: 34.5mm (without 510 connector and drip tip)
- Airflow controll: 1.2mm – 1,5mm – 2,0mm - 2,5mm for dual or single coil, and 2x1,2mm stacked for single coil use only
The Origen Genesis v2 has a huge capacity for its size, it holds up to 4ml of juice.
It has two pair of "dedicated" wick holes:
- One pair for cotton/silika with 4,5mm on the one side
- One pair for mesh with 3mm on the opposite side
I do not recommend to use the 4,5mm holes with stainless steel mesh, but you can try it of course if you wish.
The top cap is helding in place by two O-rings wich are inside the top cap.
The AFC ring is helding in place by screwing the upper part of the top cap which has the high efficiency cooling fins.
The high efficiency cooling fins aren’t only design elements, it is necessary to dissipate the heat much faster.
The polycarbonate tank (stainless steel tank will be sold separately) is fine-threaded, sealed by two o-rings, and it is secured by a threaded stainless steel ring.
Take care when disassembling and reassembling the tank section, and do it only when it is absolutely necessary! Do not overtighten!
Engraving and serial number on the bottom of the atty, around the 510 connection.
You can buy the Origen Genesis v2 only through resellers. The selling will start about mid/end of september. Here you can find the resellers, who will carry my atomizer (the list will be updated):
USA:
EU:
Russia, Israel
Australia and South East Asia region
Here the opinions off Todd for the prototype:
http://youtu.be/3hLjq22oK-s